11
MODEL: eXperience 620
NEEDLE DROP POSITION ALIGNMENT
Select the stitch pattern " "; the standard needle drop position should be at the center of the needle
plate hole.
When the needle swings in maximum zigzag width " ", the clearance between both ends of the
needle hole in the needle plate and the needle should be 0.2 mm or more. If not, adjust as follows.
ADJUSTMENT PROCEDURE:
1. Turn on the power switch, select the straight stitch pattern " " and the zigzag width at maximum
" " then check the needle drop position.
2. If the needle drop position is not in the center of the needle plate hole when the straight stitch is
selected, or if the clearance between the needle and edge of the needle plate hole on both side is
less than 0.2 mm when the stitch pattern is set to maximum zigzag width, remove the face cover
and loosen the setscrew, then adjust the needle drop position by turning the eccentric pin.
NOTE:
Make sure the eccentric pin is positioned with its off-center head facing downward.
When you have finished adjusting the needle drop position, tighten the setscrew and
attach the face cover.
A=B
Eccentric pin
Setscrew 3x4
Needle plate hole
0.2 mm or
more
0.2 mm or
more
Eccentric pin position
(Off center head)
Adjust the needle drop position by turning the eccentric
pin as shown
