STINGER – Owner’s Manual – Ver: 2.31
6
Elmwood Amps
GETTING STARTED
Getting started
1. Connect the amplifier to the mains. Always connect the mains to an earthed
outlet with a 3 pole CE approved mains cord.
2. Make sure that there’s a speaker cabinet connected to the appropriate jack
socket, regarding impedance, on the back of the amplifier.
3. Make sure that you are using a correct speaker cable for the speaker
outputs. Low signal cables, such as regular guitar cables, might seriously
damage the output stage of the amplifier.
4. Connect the accompanying foot switch to the jack socket marked “Foot
Switch” on the back panel.
5. Set the switch marked "Power" to position ON.
6. Check that the built in fan can operate without obstacles. Assure that there
is a free space of minimum 15 centimetres at the rear of the amplifier.
7. Check that Volume and Gain are set fully counter clock wise on both
channels.
8. Set the EQ controls, Treble, Mid, Bass and High cut to their middle
positions, 12 o’clock.
9. Set the two bright switches to their middle position respectively.
10. With the footswitch connected, press the switches on the footswitch so the
led’s goes dark.
11. Allow the amplifier to build up heater and bias voltages
for approximately 30
seconds before switching on the Standby switch.
The amplifier is now ready for use.
Plug in your guitar in the Input jack socket.
See section “Channel 1” and “Channel 2” for making some sound.
Note:
Never operate the amplifier without a connected speaker
since this can cause severe damage to the amplifier.
