M60 / M90 Modena – Owner’s Manual – Ver: 2.31
7
Elmwood Amps AB
CHANNEL 1
Channel 1
•
Press the Channel switch on the foot switch so that the led will go dark to
activate Channel 1.
By adjusting Volume, Treble, Mid and Bass you can change the sound and vary from
clean to distortion. The EQ section is very effective and you will not have any problem
finding your favourite sounds.
For cleaner sounds it’s recommended to keep the channel 1 volume control below 12
o’clock
(some low output single coil equipped guitars might stay clean beyond 12
o’clock, while a hum bucker equipped guitar needs lower settings for clean sounds)
and adjust the overall output with the master volume(s).
Channel 1 – Drive mode
•
Press the Boost/Drive switch on the foot switch so that the led will light up.
You have now activated the Drive mode.
•
Still on Channel 1 - slowly turn up the controls for Drive Ch1 and Drive Ch1
Volume.
The Drive Ch1 control decides the amount of distortion and the Drive Ch1 Volume
control controls the volume in drive mode.
The EQ section and the Volume on Channel1 are still active also when Drive is
activated.
By adjusting the controls for Drive Ch1 and Volume differently, there are a wide range
of different sounds to achieve - from lightly break-ups to heavy crunch.
•
To turn off Drive mode; simply press the Boost/Drive switch again.