Removing the Monitoring System
MEMS 3000 HomeStation Installation Guide
6-
1
Chapter 6 Removing the Monitoring
System
In some cases it is required to remove the monitoring system before the
defined confinement period is completed. Before disconnecting and
removing the MEMS 3000 HomeStation, an end of service procedure should
be performed.
Note that performing an end of service before disconnecting and
removing the MEMS 3000 HomeStation is essential to preserving the unit’s
internal backup battery.
Performing an End of Service
In order to perform an end of service, perform the following steps:
1. Using a mobile phone, call the monitoring center and ask the monitoring
personnel to perform a manual end of service.
2. The monitoring center personnel will call back to confirm a successful
end of service. You can now disconnect and pack the MEMS 3000
HomeStation into its original package.
It is recommended that only experienced personnel remove the MEMS
3000 HomeStation
AMS Exhibit 1104-18
