Elmo TT-02U, Instruction Manual

Page: 5 / 67

5
English P1~P33
WARNING
: Handling
the cord on this product
or cords associated with
accessories sold with this
product, will expose you to
lead, a chemical known to
the State of California to
cause birth defects or other
reproductive harm.
Wash hands after
handling.
FOR UNITED STATES USERS:
INFORMATION
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant
to Part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment
generates, uses, and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio or
television reception. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause
interference to radio and television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures.
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
USER-INSTALLER
CAUTION:
Your authority to operate this
FCC verified equipment could
be voided if you make changes
or modifications not expressly
approved by the party responsible
for compliance to Part 15 of the
FCC rules.
WARNING:
TO REDUCE THE RISK
OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE
THIS PRODUCT TO RAIN
OR MOISTURE.
The connection of a non-
shielded equipment interface
cable to this equipment will
invalidate the FCC Certification
or Declaration of this device
and may cause interference
levels which exceed the limits
established by the FCC for
this equipment. It is the
responsibility of the user to
obtain and use a shielded
equipment interface cable
with this device. If this
equipment has more than one
interface connector, do not
leave cables connected to
unused interfaces. Changes
or modifications not expressly
approved by the manufacturer
could void the user’s authority
to operate the equipment.