e-mail:
internet:
www.elmes.pl
Elmes Elektronik 12.2015. All rights reserved.
Installation
The control units should be installed with 230VAC wiring terminals in upwards direction and white antenna wire let
loose downwards (not glued or fitted to wall). External directional antenna may be screwed to antenna terminals and
the white antenna wire removed. Screening of external antenna coaxial cable should be connected to ground terminal
while signal wire to A terminal. Care should be taken not to expose the control unit to harsh environmental conditions
such as very low/high temperatures or high humidity. Two screws are provided for fitting the control unit to wall.
Description of ST..H control unit 230VAC wiring terminals:
L
- 230VAC mains supply
LIVE
wire terminal,
N
- 230VAC mains supply
NEUTRAL
wire terminal,
PE
- 230VAC mains supply
GROUND
wire terminal,
PE
- electric motor
Ground
wire terminal,
OPEN
- electric motor
LIVE
wire terminal (
opening rotation
),
middle
- electric motor
Neutral
wire terminal,
CLOSE
- electric motor
LIVE
wire terminal (
closing rotation
),
- courtesy/warning 230VAC lamp
LIVE
terminal.
ST..H wire control terminals (NO ANY VOLTAGE ALLOWED!)
COM
- common wiring terminal,
OP
- wired wall switch terminal - opening rotation,
CL
- wired wall switch terminal
– closing rotation,
RS
- reset photo/infrared barrier beam terminal.
Must be wire
shorted to COM terminal if barrier is not fitted.
Specification
mains supply 230VAC (2VA) control panel with superheterodyne receiver for 433,92MHz band,
relay outputs for motor control, 2 x NO, max 16A/250VAC,
courtesy/warning control relay output : max 5A/250VAC,
infrared obstacle detection barrier NC type (normally closed),
electric motor operation time range (opening and closing) 1s
4 min,
programmable PAUSE time: 1s
4 min,
control panel external dimensions (l/w/h) 87/87/39mm,
open field maximal operating range: up to 100m for ST100H set and up to 200m for ST200H set.
Manufacturer
ELMES ELECTRONIC, 54-
611 Wrocław – PL, ul. Avicenny 2, tel. (+48) 71-784-59-61, fax (+48) 71-784-59-63
Manufacturer’s Limited Warranty:
Elmes Electronic remote control sets carry two
year manufacturer’s warranty as from date of purchase. The warranty is
limited to the replacement of faulty original parts or repair defects of improper manufacture. Damage, faulty use or
improper handling by the user or installer as well as any changes in product’s hardware or software caused by the user
violets the warranty and all due repair costs will be charged. Elmes Electronic shall not be responsible for any damage
human or material caused by its products failure to operate correctly.
Elmes Electronic reserves the right to change product specification without prior notice.
KEELOQ
®
is a registered trademark of Microchip Technology Inc., USA.
WARNING! Control unit and electric motor connection to
230VAC mains voltage require personal safety care pro-
cedures to be taken and mains voltage line be in off
state at installation.
IMPORTANT! 230VAC supply LIVE wire must be con-
nected to L terminal and NEUTRAL wire must be con-
nected to N terminal.
