10 of 15
assembling.
4,Connect the curved pole to the straight pole.see Fig.2
then put 3pcs M6X8 in the corresponding holes,tight them by
tools.Please pay attention that Do not damage the wire cable
during the assembling.
5,Connect the whole poles to the round base with 4pcs
M8x8 screws. See Fig.3
6,Connect the round based to the ground by expansion
screws.see Fig.4
7,Connect the heating mould to the heater stand mould by
M8X50 and 2pcs M8X10 screws.Connect the easy fitting plug
devices between the heating mould and heater stand
mould.and tight them.see Fig.5
8,Turn on the switch and connect the power,to check if the
heater can work well.
9,Don’t move,cover or climb the heater while it is working.
See Fig.6
Pay attention to the mounting place and all mounting
material(dowels, screws). Ensure they are suitable and
stable enough for mounting and lastingly holding of the
appliance.
Pay attention that, the installation of the appliance must
not add excessive wind load.
Adjust the desired angle of radiation and fest screw all
screws. Check regularly the screw's connection. Mechanical
bearing pressure and oscillation due to wind or rain could
lead to loose.
