page 5
5. Fan Assembly (with downrod). (cont.)
With the hanging bracket secured to the outlet
box and able to support the fan, you are now ready
to hang your fan. Grab the fan firmly with two
hands. Slide downrod through opening in hanging
bracket and let hanging ball rest on the hanging
bracket. Turn the hanging ball slot until it lines up
with the hanging bracket tab.
Tip
: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
Continue to the "Wiring" section for wiring
diagram.
6. Fan Assembly (flushmount).
canopy
canopy cover
hanging ball slot
hanging bracket tab
canopy
motor housing
hanging bracket tab
Remove and set aside canopy cover to reveal
6 holes. Notice that 3 holes are larger than the
others.
If there are only
3
screws in top of motor
housing, please proceed to next paragraph. If
there are
6
screws in top of motor housing,
remove every other screw and lock washer.
Remove pin, clip and set screws from motor
housing yoke. Thread wiring through canopy.
Place canopy over yoke, aligning larger holes
in canopy with the 3 existing screws in top of
motor housing. Insert the 3 screws and 3 lock
washers that were removed (if there were
only 3 screws located in top of motor housing,
these screws/lock washers will be located in
one of the hardware packs) into the
remaining holes. Securely tighten these
screws.
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over
the hanging bracket tab. (Use one of the
non-slotted holes on the rim of the canopy to
do so.)
canopy
motor housing
yoke
pin
clip
set screw