Assembly & Installa�on
Step 1 (fig.1) Fix the upper wall bracket on a solid wall or pole. If you have any doubts consult a
professional. The advised height to fix the upper wall bracket is +/- 2000mm (this height depends on the
height of the operator)
Step 2 (fig.2) Slide the main support arm into the upper wall bracket
Step 3 (fig.3) Fix the lower wall bracket to the wall approximately 1000mm below the upper wall bracket.
Step 4 (fig.4) Assemble lower wall bracket
Step 5 (fig.5) Li� the main support arm to its horizontal posi�on. Install pole support clip (A) and test
telescopic slide by li�ing lever (B)
Step 6 (fig.6) Slide the Umbrella head and pole into the end clamp. Ensure that the Umbrella is
orientated with the push bu�on (D) to the front. Check that the fit is neat, then �ghten knob (C)
Step 7 (fig.7) To open the Umbrella - Press bu�on (D) and pull down on the Umbrella pole so that the
Umbrella is completely open. Note that the hinged elbow joint (E) must be clear of the main support arm
clamp, then swing the pole up into the pole support clip.
Your Grace 10 Umbrella is now assembled and ready for use
.
Opera�on
Telescopic Arm 1400-1800mm: To adjust the extension length, li� lever (B) and slide the Umbrella in or
out to the desired posi�on.
Horizontal swing: (fig.8) Turn the handle (F) an�-clockwise to loosen. When the Umbrella is swung into
its desired posi�on, turn the handle clockwise un�l �ght to lock the Umbrella posi�on. If the handle has
been turned a full rota�on and it is s�ll not �ght, you can pull down on the handle so that it is in free mode
and twist it back before releasing the handle allowing it to spring back up and �ghten further.
Umbrella Tilt: (fig.9) Pull on knob (G) and the Umbrella will �lt 10 degrees into its �lt posi�on. To set the
Umbrella back in its standard posi�on, simply pull on knob (G) again and li� the Umbrella un�l it locates
back in its standard posi�on and the locking knob clicks back into place.
Closing the Umbrella: If s�ll extended, slide the telescopic arm back into its closed posi�on. Remove the
Umbrella pole from support clip (A) and swing down so that it hangs ver�cally. Press bu�on (D) and push
the pole up un�l it clicks into its closed posi�on. While s�ll holding onto the pole, pull knob (G) and lie the
Umbrella flat against the main support arm. Now li� the main support arm so that it slides partway up and
out of the upper wall bracket exposing the pivot point. The Umbrella can then be lowered down so that it
locates into the lower wall bracket.
Always close your Grace 10 when not in use.
GRACE 10