111/112
WL31/WL31TG
15.11 GSM IMG30 MODULE
Type:
GSM telephone line interface
Frequency:
900 and 1800 MHz
Power:
2 W
Powering:
From WL31 control panel or dedicated battery, 3.6 V
power
Absorbed power:
0 mA (resting); 420 mA max (transmitting)
Aerial:
Dipole (supplied)
Aerial connector:
SMA type
SIM Card:
3V
– 1,8V standard
Messages send method:
As for STM30 plus SMS
Working temperature:
0°C ÷ +55°C
15.12 PS30 POWER SUPPLIER
Type:
Switching power pack
Input tension
230 V~ 50Hz +10 -15%
Output nominal tension:
3,6 V─
Maximum deliverable power:
0,8 A
Maximum ripple:
25 mV
Input connection:
Screw clamps
Working temperature:
0°C ÷ +55°C
PLEASE REMEMBER...
The control panel, during a preliminary stage that comes before the acquisistion stage checks
the radio noise of the surrounding environment and proposes the best radio channel. For this
reason the devices must be acquired in the same location where they are to be installed.
In order to have a correct acquisition procedure, the LED of every acquired device must stay
on glowing steadily until the acquisition procedure is concluded.
Press the device tampers (any key for remote keyboards) to activate the radio communication
with the control panel, only after quitting the acquisition procedure. Full communication will
be obtained after about 10 minutes.
Before installing the devices, check for radio range.
During installation operations the central uit must be set in "Maintenance" status.
When turning off power to one or several devices or to the control panel, full radio
communication will be obtained afetr about 40 minutes).
After installing the devices, check for radio range again.
DECLARATION OF CONFORMITY TO DIRECTIVE 1999/5/EC
Hereby
Urmet S.p.A., declares that the WL31 and WL31TG control panels are in compliance with
the essential requirements and other relevant provisions of Directive 1999/5/EC.
The declaration of conformity may be consulted at
Elkron Customer Service.
