MADE IN TAIWAN
QUICK GUIDE
DS80HA02-002A
ENGLISH
RM600
POWER METER PLUS RELAY SWITCH
Connections
The use of AWG 16 or Ø 1mm cables is recommended.
1. Connect the Phase Output and Neutral Output terminals to the load
2. Connect the power relay to the Phase Input and Neutral Input of the 230Vac
power supply. A fast flashing of the LED indicates that the device is now ready for
the learning phase to the system.
3. It is possible to connect an external switch, "parallel" to the power relay, as
shown on the side, to switch the connected load on / off.
Joining the Network
Please follow the steps below to join the Power Relay Switch into the network.
Connect the Power Relay Switch to power cable.
Set the control unit to learning mode (see the instruction manual of the control unit for details).
Press and hold the Function button for 10 seconds, then release it to join the network. If the device successfully joins
the network, the LED Indicator will flash twice to confirm.
Removing Device from Network (Factory Reset)
Factory Reset function can clear the device of its stored setting and information and prompt it to search for new network.
1. Press and hold the function button for 10 seconds, then release the button to reset the Relay Switch.
2. The device will perform its factory reset.
3. Fully follow the previous instructions to join again the device
IMPORTANT NOTE
: DO NOT
use the Power Relay Switch as router for your security sensor or alarm control devices.
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, URMET S.p.A. declares that the radio equipment type: POWER RELAY SWITCH RM600
is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.elkron.com.
CLICK ON THE FOLLOWING LINK OF THE ELKRON SITE TO ACCESS THE PRODUCT
TECHNICAL SHEET AND DOWNLOAD THE COMPLETE MANUAL
:
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and electronic
equipment (WEEE).
The symbol of the crossed-out wheeled bin on the product or on its packaging indicates that this product must not be disposed of
with your other household waste.
Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the
recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of
disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the
environment. For more information about where you can drop off your waste equipment for recycling, please contact your local city office, your
household waste disposal service or the shop where you purchased the product.
ELKRON
Tel. +39 011.3986711 - Fax +39 011.3986703
www.elkron.com
– mail to: [email protected]
ELKRON
is a trademark of
URMET S.p.A.
Via Bologna, 188/C - 10154 Torino (TO) – Italy
www.urmet.com
LED indicator
Function Button
External Switch Terminal 2
External Switch Terminal 1
AC Line Power Load Output
AC Line Power Input
AC Neutral Power Input
AC Neutral Power Load Output
