26
MP500/4-8-16
1.6.6
How to delete the fault memory with operating mode “0”
Fault memory is deleted automatically at next arming of the partitions associated to the fault, or manually directly from the menu.
To delete fault memory manually from the menu proceed as follows:
1) Enter
<Master / User / Installer / Technical Manager code>
, press
twice.
2) Press
. The fault LED will blink.
3) Use
and
to scroll the list of faults.
4) He following after examining the list:
5) Press
to delete the Tampers Memory.
6) Press
repeatedly to exit from the menu after examining the list.
1.7 HOLD-UP
FUNCTION
1.7.1
Disarming from keypad under hol-up
On MP500/4, MP500/8 and MP500/16 control panels, starting from control panel SW version 1.01, if the hold-up function has been
enabled and you are threatened and forced by a criminal with the risk of life then, you can disarm the burglar system while arming the
hold-up alarm simultaneously which will make the dialer sending the programmed alarm messages without activating the siren sound.
To disarm the system when your are under coercion, just increase your user code of one digit. For example if your user code is 000021
you need only to enter 000022; if user code is 29 enter 30, if it is 39 enter 40, etc.
IMPORTANT!
Enabling the hold-up function will cancel EN50131 compliance.
UT02:...
FAULT
LOW BATTERY
CONTROL PANEL
FAILURE
DELETE MEMORY?
MP500/16
12/01/2014 10:10
Summary of Contents for ELKUMP500/16
Page 51: ...MP500 4 8 16 51 ...
