Arch Linux 3.6.11-6-ach+ (tty1)
alarmpi login: root
password : imm123 (nezobrazí se)
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.88.81 netmask 255.255.255.0 broadcast 0.0.0.0
inet6 fe80::ba27:ebff:feb3:6dad prefixlen 64 scopeid 0x20<link>
ether b8:27:eb:b3:6d:ad txqueuelen 1000 (Ethernet)
RX packets 647227 bytes 52244971 (49.8 MiB)
RX errors 0 dropped 111 overruns 0 frame 0
TX packets 127242 bytes 17559508 (16.7 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 16436
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 0 (Local Loopback)
RX packets 8344 bytes 610606 (596.2 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 8344 bytes 610606 (596.2 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
- 11 -
Note: If you are not sure of the current IP
address, it is necessary to connect a USB
keyboard to the iMM Audio Zone-R, and to
connect the device to the Ethernet network.
Using the HDMI cable, you must then
connect a monitor or television, and then
connect the micro-USB power.
After 60 seconds, click the Enter key. Log in
by writing the login ID „root“ and password
„imm123“, which is not displayed for security
reasons. After logging in, write the command
„inconfig“, and confirm by pressing Enter.
In the second line after the text „inet“, you
will find the current IP address.
Then shut down the iMM Audio Zone-R
using the „shutdown -h now“ command.
Service check of IP address
