Page 10
programmed to prevent damage from over traveling.
2. RF Receiver/Control Module Wiring
1) Place a 10A fuse between the red lead of the RF Receiver/Control Module power
connector and a switched positive power lead on the vehicle. Attach the black lead from
the RF Receiver/Control Module power connector to the vehicle ground.
2) All control functions are sent to the monitor via an encoded RF signal from the
transmitter; no control wiring is needed.
3) Mark the mounting screw pattern per dimensions in Figure 10.
4) Drill four
0.203” (13/64” drill) holes.
5) Secure the unit to the panel with four #10-32 screws with nuts and lock washers (not
supplied). The length of the screws should be the panel thickness plus 3/8” minimum.
Figure 10
81496001 RF Receiver/Control Module Mounting Layout
