CARTRIDGE REPLACEMENT
Loosen cartridge nut (1) by turning it
counter-clockwise and lift out the cartridge (2). Insert
new cartridge. Reinstall the handle.
Shut off water supply. With valves in "closed" position,
loosen the set screw (1). Remove handle (2) from valve
stem. Unscrew the cap (3) from the cartridge nut (4).
Congratulations on your purchase of an Elkay product.
Although your product is extremely durable, attention should
be given to the care, cleaning and maintenance of this
product. Cleaning agents and abrasives may cause damage,
which may result in oxidation and discoloration.
By following these simple guidelines for proper care and
cleaning, it will give you years of enjoyment:
TO CLEAN: Simply wipe gently with a damp cloth and blot dry
with a soft towel. A common rule of thumb is: when you dry off,
dry off your product.
·
Avoid build-up of soap, toothpaste or mineral deposits, as
these tend to have an adverse effect on the appearance of
the product.
·
NEVER use cleaning products of any kind on this product -
especially those containing ammonia, bleach or alcohol - or
those with any form of abrasive.
CARE AND CLEANING INSTRUCTIONS
FOR CARE AND MAINTENANCE:
·
The water in certain areas of the world can be very caustic -
standing water around the product can cause damage. Be
sure to remove standing water with a dry, soft cloth as soon
as possible.
·
For polished brass finishes, as often as once a week, you
can apply a paste wax or special, non-abrasive, brass
coating (DO NOT APPLY POLISH).
·
Before applying a protective coating, gently brush the entire
fixture using a soft tooth brush. This will remove any dirt or
deposit build-up.
·
These simple steps will add temporary protective coating to
your faucet and extend the life of the finish.
Failure to follow care and cleaning will void your warranty.
For additional information, please visit elkayusa.com
.
Important: after installation is
completed, turn on hot and cold water
supplies. Check for leaks. Pull the
hose assembly out of the spout and
remove the spray head by unscrewing
it from the hose counterclockwise. Be
sure to hold the end of the hose down
into the sink and turn the faucet on to
the warm position where it mixes hot
and cold water. Flush water lines for
one minute. Check for leaks.
Re-tighten any connections if
necessary, but do not overtighten.
Reinstall spray head by hand
tightening it back onto the spray hose.
1
2
3
4
1
2
