1000002042 (Rev. F - 08/17)
EMASMB*A & LMASMB*A
Page 2
FINISHED FLOOR
6 1/4"
159mm
4"
102mm
ADA DEPTH
27"
686mm
ADA HEIGHT
38 1/2"
977mm
42 1/8"
1069mm
‰
OF BUTTON
46 1/2"
1182mm
48"
1219mm
ADA HEIGHT
64 3/8"
1635mm
FINISHED FLOOR
7"
178mm
7"
178mm
‰
22"
559mm
40 1/2"
1029mm
45 5/8"
1159mm
44"
1118mm
6"
152mm
MINIMUM
CLEARANCE
3/8"
9.5mm
WATER
INLET
"A"
3"
76mm
1-1/4"
31.7mm
DRAIN
"B"
FILTER USED ONLY
IN LMASMB UNITS
7/16" X 3/4"
11mm X 19mm
OBROUND
MOUNTING
HOLE (6)
"C"
O
3/8"
8mm
(6)
MOUNTING BOLT
DRAIN TRAP
CUSTOMER
SUPPLIED
ROUGH-IN
EMASMB & LMASMB
ADA STAND-ALONE MOUNTING
LEGEND:
A = RECOMMENDED WATER SUPPLY LOCATION; 1/2" IPS MAXIMUM PIPE SIZE. SERVICE STOP VALVE NOT FURNISHED.
B = RECOMMENDED WASTE LOCATION. WASTE SHOWN IN WALL BUT MAY BE BEHIND WALL.
OUTLET 1-1/4” O.D. (TRAP NOT FURNISHED)
C =7/16" X 3/4" OBROUND MOUNTING HOLES FOR FASTENING BACKPLATE TO WALL.
Pre-Installation (reference Rough-Ins, Fig. 1 and Fig. 2)
1.
Ensure Wall is structurally sound
to bear the loads imparted by the EMASMB or LMASMB Bottle Filler
(On-Wall Bottle Filler). If necessary, install a Wall Support Carrier (not supplied).
2.
Ensure Water Supply Line and Drain Line are sized
and located as specified the Rough-in diagram.
3.
Attach Service Stop Valve (not supplied) to Water Supply line
orienting the 3/8"O.D. female compression
outlet horizontally to the left. Purge water line and test for leakage. Correct any leakage.
FIG. 1
IMPORTANT!
INSTALLATION NOTES:
• Ensure wall is structurally sound to bear the loads imparted by the Surface Mount Bottle Filler.
• Ambient air temperature limits: 10°C - 38°C (50°F - 100.4°F). Climate Class SN-ST.
• Not suitable for installation in areas where water jets could be used.
