WARNING: please carefully read and properly follow the instructions for installation found in this manual.
STEPS:
5
Tighten the shower (E) to the hose interposing
the gasket (D3) and con
fi
rm the hose can slide
smoothly through the passage hole.
CARTRIDGE REPLACEMENT
6
Connect the
fl
exible hoses to the supply connections
with rubber gaskets.
Secure with wrench.
Turn on the water and check for leaks.
3/8”
[10 mm]
Hot
Cold
Red
Blue
D
3
E
3
2
1
Before inserting the single lever group in the hole of
the sink, make sure that the base gasket is properly
positioned in its seat and that the
fl
exible hoses are
well tightened to the body of the tap.
Place the single lever group in the hole of the sink,
orienting the spout toward the sink tank.
For countertop thicknesses less than 1/16” thick
use the
fl
ange (B1), for all other installations use
the metal washer (B2).
Secure mounting hardware in place by tightening
mounting nut (B3).
Install the check valve (C1) to the outlet hose with a
rubber washer (C2).
Secure with wrench.
Attach the pull-down hose to the bottom of the
check valve with a rubber washer (D1).
Secure with wrench.
13/16”
[20 mm]
1/2”
[13 mm]
4
Attach the counterweight (D2) to the
fl
exible hose
approximately 15-3/4” [400mm] from the connection
to the outlet pipe.
B
3
B
2
B
1
A
C
2
D
1
C
1
13/16”
[21 mm]
D
2
3
2
1
Before dissassembling the faucet be sure that the water supply is turned off.
Remove the
fi
nish cap (A), paying attention not to damage it. Remove the setscrew (B) with a 1/8” [2,5mm] hex wrench. Remove the handle (C). Lift the
fi
nishing ring nut (D)
using the reference notch. Unscrew the cartridge nut (E) then pull out the cartridge (F). Put the new cartridge into the body of the faucet, checking that the two centering pins
enter into the respective seats (X) and that the gaskets on the cartridge are well positioned.
Reassmble the handle following the instructions in reverse order.
B
A
C
X
1/8”
[2,5 mm]
F
E
1-1/8”
[28 mm]
D
