ELK-319PIRW Wall Mounted Wireless PIR Sensor
Description
The ELK-319PIRW is a Supervised Wireless PIR (passive
infrared) Motion Sensor designed for wall mounting
applications. It detects movement within a specific area by
sensing the infrared energy emitted from a body as it moves
across the sensor field of view. When motion is detected, the
sensor transmits an alarm signal to the control panel. Additional
transmitted signals include: tamper, hourly supervisory, and
low battery. The sensor is powered by one (1) replaceable
3VDC lithium battery.
This sensor is compatible with Elk’s 319MHz Receivers/Panels
as well as many other panels that operate on the 319.5MHz
Frequency and adhere to the ITI/Interlogix protocol.
Specifications
RF frequency: 319.5 MHz
Compatibility:
ELK-319 Receivers/Panels & other
319.5MHz learn-mode control panels
Battery type:
One (1) 3VDC lithium battery
(Panasonic CR123)
Tamper Switch: Sealed dome-contact
Sensitivity:
2 event or 3 event
Operating Temp: -40 to 131°F (0 to 49°C)
Storage Temp: -30 to 140°F (-34 to 60°C)
Max. Humidity: 90% Relative Humidity non-condensing
Dimensions 3.2H x 2.4W x 1.7D
Programming (Enrollment)
The following is a general guideline for programming (enrolling)
a sensor into the receiver or panel. For more extensive
instructions please refer to the receiver or panel instructions.
1. Place the panel into the Program mode.
2. Proceed to the WIRELESS SETUP menu.
3. Select the appropriate zone/sensor location number.
4. When the panel prompts to trip the sensor do the following:
• Separate sensor from the mounting base
• Remove battery pull tab (if present) to power the sensor
• The panel should acknowledge sensor has been learned
by a display on the keypad and/or audio alert (depending
on the panel). If enrollment does not succeed repeat the
process by removing and reinstalling the battery OR try
pressing and releasing the tamper plunger.
5. For additional sensors of this type repeat the above process.
Proceed to the zone programming to assign each sensor’s
zone definition.
IMPORTANT: Set Zone Loop as “1” for this sensor.
6. Exit the panel Program mode when finished.
Pet Immunity
The ELK-319PIRW is designed to allow the presense of pets
(up to 22lbs.) without signaling an alarm. It has a special micro-
element lens array, producing much stronger optical signals for
humans than for pets 22 lbs. or lighter.
Pets come in many varieties. Some pets (especially larger ones
with very short hair), even if lighter than 22 lbs. may produce
enough infrared radiation to cause alarms. Users are strongly
encouraged to test sensor with their own pets, in order to verify
that the sensor will not signal ana alarm when their pets are
moving within its field of view.
Sensor Disassembly & Base Mounting
Use screwdriver to push the latch at the
bottom of the sensor and then lift up
on cover from bottom to remove.
Identify necessary holes:
1. For flat wall mounting, use keyhole shaped holes in base.
2. For corner or 45 degree mounting, use drill to open at
least 2 of the holes in base (L & R) side depressions.
Sensitivity setting
Set Jumper JP2 per diagram
Hi Sensitivity - Detection should
occur in about 2 to 4 steps.
Std Sensitivity - Detection should
occur about 3 - 5 steps.
TM
Interlogix is a registered trademark belonging to United Technologies.
Coverage Pattern
30ft
20ft
10ft
0
10ft
20ft
30ft
| Range = 40ft Max. |
