INSTRUCTIONS
..
BEFORE USING:
Before using the unit for the first time and also after each use,
wash the basket, percolating tube and interior of the coffeemaker with hot soapy
water. Rinse thoroughly and dry with a try towel. Wipe the exterior with a damp cloth.
NEVER IMMERSE THE BASE IN WATER OR ANY OTHER LIQUIDS. NEVER USE
ABRASIVE CLEANSERS TO CLEAN THE EXTERIOR!
WATER:
Remove the cover of the unit and the coffee basket. Fill the unit with fresh
cold water to desired quantity line. Do not fill coffeemaker past the top measurement
line.
NEVER USE HOT WATER TO MAKE COFFEE!
COFFEE:
Tip: Wet the bottom of the coffee basket to prevent the coffee grounds
from filtering through into the freshly brewed coffee.
Measure the desired amount of coffee into the basket, then set the basket onto the
percolating tube. Place the bottom of the tube into the heating well,
DO NOT FORCE!
Place cover of the coffee brewer onto the unit.
(No separate plate is necessary since
the cover already operates as a water spreader.)
SAFETY COVER LOCK (BEFORE BREWING):
When placing the cover onto the
coffee brewer, place the cover the tabs centered in the front and back; turn the cover
clockwise until the tabs slide into the slots and the marks are aligned. To remove the
cover, simply turn it counter clockwise and lift it off.
BREWING:
First plug power cord into an AC outlet. Always use a 110-120 Voltage
outlet. Upon completion of coffee, the indicator light will signal when the coffee is
ready to serve. After brewing, the coffee brewer will automatically set itself to low
heat and keep the freshly brewed coffee warm and fresh until the unit is unplugged.
COFFEE DISPENSING:
Press dispensing lever forward and
hold down until coffee cup is filled to desired level. Release the
lever and the dispenser will automatically close. For
continuous
pouring
(to fill large carafes or pots), rotate the lever 90
to the
LEFT
or
RIGHT. Pull down on the lever
to “lock” into position.
After use, simply lift up the lever, rotate it back into the forward
position.
MEASURING GUIDE:
Below is a suggested guide to measure out coffee to the
desired quantity to meet your preferred taste.
Always allow the brewing time to be approximately 1 ½ minutes PER cup. Any
voltage or water temperature variations will affect the brewing time and cycle.
CAUTION: NEVER BREW/RUN THE UNTI DRY! NEVER IMMERSE BASE INTO
WATER! CLEAN THE UNIT ON A REGULAR BASIS!
SAFETY CIRCUIT BREAKER
..
IMPORTANT NOTICE:
In case of over heating due to insufficient amount of water in the coffee brewer, the
safety circuit breaker located on the bottom of the unit will automatically switch itself off.
This will prevent the unit from over heating or damaging the surfaces in which the unit is
placed.
Once the coffee brewer has cooled off, in order to operate the unit again, you
MUST
locate the circuit breaker on the bottom of the coffee brewer and switch it back on in
order for the unit to operate again. If you fail to switch the circuit breaker back on, the
coffee brewer will not power on.
The circuit breaker is a small indented hole located beneath the unit. To switch it back
on, you will nee to take a small pointed object such as a pen, toothpick or pin to poke
into the hole.
