Rev.081116-MZ
4
www.elitescreens.com
12 Volt Trigger (Item, C)
Connect the
12 Volt Trigger (C)
to the
Wall Box (F)
for set up to your projector.
Wall Box (F)
12 Volt Trigger (C)
Red Wire +
DC12V
Green Wire -
0V
Connect to Projector
Wireless 5-12v mono trigger cable (H)
5.
5-12 volt trigger
(Item C, Fig 4):
The built-in 5-12V trigger input allows your screen to synchronize its
drop & rise with the projector’s power cycle. The screen deploys when the projector powers up and will
retract when the projector powers down. The 5-12 volt RJ45 cable connects to your projector’s trigger output
via a separate cable that may or may not be provided by the manufacturer of the projector. The trigger
feature will not work without an output cable from the projector, but it can be tested by connecting the Red
(+) and Green (-) cable to a 9-volt battery.
6. Wireless 5-12 volt trigger (Item F, Fig 5):
The RF
remote control serves as a dual purpose, independently
as a handheld remote control, or in conjunction with the
Wireless 5-12 volt trigger cable. The radio frequency
technology can be programmed to send a wireless
signal to synchronize its drop/rise with the projector’s
power cycle.
Fig.4
Here’s how to set up your Wireless 5-12 volt trigger | Synchronization Instructions
Step1
: Connect one end of the 3.5 mm wireless 5-12 volt trigger cable to the RF remote.
Step 2
: Connect the other 3.5 mm end of the wireless 5-12 volt trigger cable to your projector
Step 3
: Make sure to unplug your screen from the power outlet
Step 4
: Hold the
UP
button on your RF remote
Step 5
: While holding the
UP
button, plug the screen back to the power outlet
Step 6
: Wait 5 seconds and then release the
UP
button
Step 7
: Your 5-12V wireless trigger should now be activated with your screen and ready to be used and able to
control your screen with your projector’s power cycle.
Repeat the steps again if not successful.
(Please be aware, the projector on/off cycle may take longer to fully activate. It usually takes around 20-30seconds for
full off and on cycle each time)
For a local Elite Screens contact or Technical Support, please visit
www.elitescreens.com
DC 5-12V
The back of the
projector
Wireless5-12V trigger cable
UP
Stop
Down
Fig 5
5-12 Volt Trigger Cable