MZ04242018
4
II. Suspended
1. Screw the
eyebolt
(G) onto the
bracket connector
(D).
2. Attach the
snap link
(H) through the
eyebolt (G)
and connect it to the ceiling eyebolt screw (not included)
as rated for the screen’s weight.
Screen material tension adjustment
(4mm Allen Wrench required and not included)
Remove the weight bar end cap to expose the adjustment tension knob. This knob has a 4mm Allen port.
Insert your 4mm Allen Wrench and push in the adjustment tension knob, turn clockwise and your screen will
gain more tension. Turn the Allen Wrench counter clockwise and the screen will lose tension. Please note
this adjustment is not necessary as the tension of the screen has been pre-set to its factory drop setting. If you
would like to adjust the screen tension, please contact Elite Screens® for assistance to avoid damaging the
screen and voiding your warranty.
Saker Tab-Tension Series | Controls and Accessories
A. IR Remote
B. RF Remote
C. Wall switch control box
D. 5-12 volt trigger cable
E. IR extended “eye” receiver
F. Wireless 5-12v trigger cable
G. AAA batteries
H. Bubble leveler
Ceilin
g
