Rev.05242021JA
wwww.elitescreens.com
4
Screen Setup
Screen Operation
Electric current
: The screen operates on AC 110V at 60hz (US/Canada/Mexico only)
1. Plug the screen into a power outlet and control the screen using the included remote controls.
2. Once the screen has power, you will be able to control it using any of the 3 methods below.
Three ways to control your Kestrel Tab-Tension Screen
1.
IR Remote control:
The IR (Infrared) remote requires line-of-sight to the IR sensor. Plug the IR sensor into the
RJ11 port on the left side of the screen’s case. Point the IR remote directly at the IR sensor to control the screen.
Note:
a. The IR remote has a range of 15 ft.
b. The IR sensor must not be covered or blocked.
Minimum space required if concealed.
Side view of control panel (left side)
RJ11 Pinout
1.5V Infrared Voltage
2.IR Signal
3.12V Trigger GND
4.12V Trigger
5. /
6.IR GND
Kestrel Tab-Tension Controls and Accessories
A. IR Remote
B. RF Remote
C. IR “eye” Sensor
D. 12 v trigger cable
Length
78.7” (2 m)
Length
11.8” (30 cm)
9” – 9.8”
(230mm
– 250mm)
5.1”
(130mm)
8.18”
(208mm)
5” (128mm)
Power socket
12V trigger/
IR Sensor
DOWN
UP
IMPORTANT:
The screen must be
placed in horizontal position on a
level ground.
