2.
Use the Vertical Adjuster to position the appropriate height of the Vertical
Extension Bar
*Note: Different tripod models have different vertical
Adjusters. It could be a release button that loosens when depressed or it
will be circular knob that will loosen or tighten by twisting it in a
clockwise & counter-clockwise rotation.
3.
After using the Vertical Adjuster to (raise/lower) the Vertical Extension
Bar and set the screen height at the top, Use the adjuster switch on the
Carrying Handle to establish the level of the screen’s bottom elevation.
You can repeat steps 2-3-4 to adjust various top levels of screen height.
Repeat 3&4 to adjust the bottom level screen height.
When Packing Up the Tripod Screen:
1.
Reverse the steps above to pack up the screen and put
away.
2.
Hold the extension bar and use another hand to release the
Vertical Adjuster.
*Note:It is very important to remember
to hold the extension and then unlock, or it will cause
damage to the screen.
3.
Turn the screen in a vertical position as reversed to that
shown in Fig. 1.
4.
(
See Fig. 3
) Bring down and tighten the vertical extension
bar making sure that the spur on the bottom of the top
hook connects with the hole in the end cap.
5.
Lastly tighten the vertical adjuster.
Notes:
1.
To ensure the screen is stable, extend the tripod’s legs as
much as possible.
2.
Do not fold the screen or allow any sharp objects to touch the
screen’s surface.
3.
Clean the screen surface often when needed.
4.
Careful use will extend the lifetime of this product.
Fig. 3
Rev 1.1
