U00258
4
B.
Wall Mount | End caps (not movable)
Step1:
Determine where the screen will be installed. Measure the distance
between each keyhole at end of end caps. Mark the screw hole locations,
drill the holes and insert the hollow wall anchors (D) [
if installing on
drywall
] and secure with a screw (C).
C.
Suspended Ceiling Installation (Additional hardware required)
1.
Fasten the Nut (E) to the Eyebolt (B) and screw it on the Bracket connector (H)
2.
Install an eyebolt screw or any other hardware to the ceiling (not included).
3.
Hang the screen to the ceiling using the snap link (G
).
Screen Operation
CAUTION: Do not let go of the handle when the screen is retracting to avoid damage from slamming up.
Note:
Always
pull the screen down and retract it in a 90-degree vertical angle. Do not allow the screen to touch
the screen case when the screen goes up or comes down to avoid damaging the screen material.
Size
X= End cap keyhole distance
106”
2702mm (106.38”)
125”
3138mm (123.54”)
140”
3454mm (135.98”)
Correct
Incorrect
Don’t tighten the screw.
Leave about 5mm (0.2”).
C
E
B
G
Ceiling
Keyhole located on
back of end cap
1
2