Rev.04/28/17 DR
5
www.eliteproav.com
Screen operation
To lower
the screen, grasp the bead chain length closest to the wall and pull downward.
To raise
the screen, grasp the bead chain length furthest from the wall and pull downward.
Please note the following points to avoid reducing the life-span of the bead chain.
1. The chain should be pulled straight down. Do not to pull the chain in any angle outwards or to the sides.
In doing so, the chain will scratch the housing of the screen.
2. The chain should be pulled down in a constant motion.
DO NOT
pull and stop the chain rapidly to avoid
shaking and damaging the screen which can be dangerous if not properly fastened and secured.
3. When pulling down the screen with the chain, please note there is a limiting device on the bead chain to
keep the screen from rolling down too much. Bear in mind that the screen can deploy as far as indicated in
the spec sheet.
DO NOT
pull down on the bead chain any harder than needed to deploy and retract the
screen. Vigorous operation of the chain can cause damage to the unit.
4. Failure to follow these instructions will void your warranty.
Screen Material Tension Adjustment
(4mm Allen Wrench required and not included)
Remove the weight bar end cap to expose the adjustment tension knob. Insert your 4mm Allen Wrench to
push in the adjustment tension knob, turn clockwise and your screen will gain more tension. Turn the Allen
Wrench counter clockwise and the screen will lose tension. Please note this adjustment is not necessary as
the tension of the screen has been set to its factory setting for best performance. Please contact
EliteProAV™ for assistance to avoid damaging the screen and voiding your warranty.
Screen down
Screen up
