07212020JA
2
The product settings are designed to provide reasonable protection against any radio interference within a
residential installation. If properly installed, the Saker Tab-Tension screen may suffer from RF interference from
other home electronics.
Although radio interference affecting other household electronics is unlikely, the following steps can be taken
should RF interference occur.
Reorient or relocate the receiving antenna on the device that may be casing the interference.
Increase the distance between the screen and the interfering device’s receiver.
Connect the projection screen to another power source apart from the interfering device.
SCREEN MAINTAINANCE
Dust, dirt and scratches on the projection screen surface will affect the quality and performance of the projection
image. For optimal results we advise to pay attention to the following instructions.
1) The screen surface has a horizontal linear structure.
DO NOT
wipe the screen up and down or in a circular
motion.
Wipe gently from left to right only
.
2) Clean the dust on the screen surface with a soft brush or microfiber cloth. A rough/coarse towel or cloth may
damage the screen’s surface.
3) Gently wipe the screen with a lightly moistened white lint free cloth with water or with a neutral detergent
(1mL/0.33 oz) mixed with water (1000 mL/33.8 oz).
Notes
：
The following precautions should be followed to avoid damaging the material, which is not
covered under warranty.
Don’t touch the screen material to avoid leaving fingerprints.
Use gloves when handling the material.
Don’t scratch the material, as it will leave permanent markings on the screen’s surface.
Don’t point to the screen material with a fingertip or other sharp objects to prevent damage to the material.
Don’t use acetone, benzene, alcohol and any other organic solvents to clean the screen material. Using
such chemicals will permanently damage the screen.
Pre-Installation
1. Carefully unpack the screen.
2. Always handle the screen upright on a clean, level surface.
3. Keep the screen out of contact with foreign particles such as dust, sawdust, and/or liquids.
NOTE
Regardless of the mounting method, each screen should be securely installed so that vibrations or pulling on the
viewing surface will not cause the casing to become loose or fall. Included are complimentary mounting screws
that may or may not be appropriate for the installation you are attempting. Always use the correct anchors to
safely secure the screen.
This product is for professional integrators only.
Hardware Parts List
Please make sure all parts listed below are included before proceeding with the installation.
A.
Wall/Ceiling
mount bracket
x2
B. M5x60
Screw x6
C. M12
Dry-wall
anchor x6
D. Bracket
connector x2
(Installed on the
housing)
E. M5x11
Bolt Screw x4
(Attached to
Part D)
F. M5x25MM
round head
cross screws x2
G. M5x30MM
eyebolt screw
& M5 nut x2
H. Carabiner x 2