Step1. Connect the servo extension to the servo wire
of the wing.
Step2. Secure control horn onto the pro-cut slot of the
right and left wing with foam safe glue.
Step3. Insert the carbon fiber tube into the right wing,
through the pre-cut hole on the fuselage, and into the
left wing.
Step4. Secure the main wing into the fuselage with
M3*75mm screws and M3 washers
Step5. Secure Control horn onto the pro-cut slot on the
elevator and the vertical fins with foam safe glue.
Step6. Apply the foam safe glue to the pre-cut slot on
the top surface of the elevator. Install the vertical fins
into the pre-cut slot on the elevator wing. The angle
between the elevator wing and the vertical fins should
be 90 degrees.
Step7. Install Z-bend wire into the hole of the control
horn clip. Connect Z-bend wire to the servo on the
wing. Clip the control horn into the control horn clip.
Step8. Install the push rod of the fuselage into the hole
of the control horn. Clip the control horn of the tail into
the control horn clip.
Step9. Install the propeller to the motor.
The CG should be 70mm (2.7-2.8in) from the leading
edge of the wing.
