Elite Greenhouses 7'5'' VANTAGE, Instructions Manual

Page: 26 / 36

26
8. Now attach the built in base to the 2 side base sections of the greenhouse. Firstly bolt an corner
bracket/base leg on each end of the partition built in base. If you are on flags or concrete cut off the
surplus metal of the legs. Attach it to the side base walls by inserting a bolt into the bolt slot of the
side base. Line the base leg angle up with the bolt slots, put nuts on and prior to tightening move the
partition base in or out to line up with the built in base cill. Tighten the nuts.
9. You can now attach the 2 vertical glazing bars.
10. Thread the glazing beading into the channels and trim to suit. Put 3 bolts into each bolt slot, at-
tach to the bottom cill by inserting another bolt into the slot and pushing it through the hole in the
bottom cill. Moving to the top of the bar insert another bolt into the bolt slot and put through the
hole in the roof corner bar. Put a nut on finger tip tight. Do the same with the other glazing bar.
11. Utilising the extra 3 bolts inserted into each bar, attach the horizontal and diagonal bracing bars
in the same way as the original door end. Likewise with the door track support attach as before.
The partition doors should be assembled in exactly the same way as the double door frame assem-
bly earlier in the booklet. The doors in a partition are a little shorter than a standard door to facilitate
full opening. They are assembled and hung in the same way as the double doors are assembled and
hung earlier in the plan.
EXTERIOR DOOR TRACK
This top door track has no holes in, but 1 bolt slot. For double doors, you must have the door track
centrally positioned. Insert 3 bolts into the bolt slot and line them up with the 3 holes in the door
track support, put the nuts on and tighten up. To move the door track into the correct position, fit
the door (see below for door fitting) onto the track and by slightly releasing the nuts holding the
door track support you can move the door(s) up and down until they are correctly into the bottom
guide. In the bag of fittings, you will find 2 small flat bars which each have 2 holes of different size.
Attach the larger of the 2 holes in the flat bar, to each end of the top door track using the bolt chan-
nel at the back. Before tightening, slide the flat bar along the door track until the smaller hole in the
flat bar intersects the self tapping screw groove in the roof corner bar. Tighten all bolts, and repeat
the procedure at the other end of the track (double door only).