THE QUBE 200 - USER GUIDE
Gravity Fed Filling Instructions
1
Open the Manual Air Release Valve
located on top of the unit.
(D)
2
Partially open the
1.5
” Inlet Valve.
(H)
3
When the water level rises up to the
Bio-reactor’s Top Grill Plate
(C)
, close
the Manual Air Release Valve.
(D)
4
Carry on filling the unit until the Mechanical
Tri-Valve
(A)
seals itself; this happens when
a small white ball appears at the top of
the valve.
5
Fully open the
1.5
” Inlet Valve.
(H)
6
Open the Return Valve (right hand valve)
(F)
7
Switch on the main water pump.
Gravity Fed Cleaning Instructions
1
Switch off the main water pump and close the
1.5
” Inlet Valve and Return Valve.
(H) (F)
2
Open the Bio-reactor Waste Water Valve
(I)
and allow the water level to drop
to just above the top grill.
(C)
3
Close Waste Water valve.
(I)
4
Open the Manual Air Release Valve (very important).
(D)
5
Pull up The Sliding Grill via the handle on top of the unit.
(B)
6
Switch on your air pump (max 30 lpm) and plug the airline into the air valve
(E)
; this supplies
the Bio-reactor’s air cleaning system.
7
The Orbs media will start to bubble and rotate; this dislodges debris from the media.
8
After two to three minutes, drain to waste by opening the Waste Water valve
(I)
.
Close valve
(I)
when drained.
10
Unplug the airline (it is important to unplug the airline when refilling).
11
Refill the Bio-reactor by partially opening the
1.5
” Inlet Valve
(G)
. When the water level is above
the Top Grill Plate
(C)
, close the valve.
