6
S A F E T Y G U I D E L I N E S
DO NOT TOUCH
fixture housing during operation. Turn OFF the power and allow approximately 15
minutes for the fixture to cool down before replacing lamp.
DO NOT
shake fixture, avoid brute force when installing and/or operating fixture.
DO NOT
operate fixture if the power cord is frayed, crimped, damaged and/or if any of the power
cord connectors are damaged and do not insert into the fixture securely with ease.
NEVER
force a
power cord connector into the fixture. If the power cord or any of its connectors are damaged,
replace it immediately with a new one of similar power rating.
DO NOT
block any air ventilation slots. All fan and air inlets must remain clean and never blocked.
Allow approx. 6” (15cm) between fixture and other devices or a wall for proper cooling.
When installing fixture in a suspended environment, always use mounting hardware that is no less
than M10 x 25 mm, and always install fixture with an appropriately rated safety cable.
Always disconnect fixture from main power source before performing any type of service and/or
cleaning procedure. Only handle the power cord by the plug end, never pull out the plug by tugging
the wire portion of the cord.
During the initial operation of this fixture, a light smoke or smell may emit from the interior of the
fixture. This is a normal process and is caused by excess paint in the interior of the casing burning
off from the heat associated with the lamp and will decrease gradually over time. Consistent
operational breaks will ensure fixture will function properly for many years.
ONLY
use the original packaging and materials to transport the fixture in for service.
REPLACEMENT LAMP – LL-PAR 38 150W 110V LAMP
ALWAYS
disconnect devices from main power source before performing any cleaning.
ALWAYS
disconnect light from main power before replacing lamp.
NEVER
remove the ground prong from the power cable.
Power cords should be safely routed and secured so they are not likely pinched.
Disconnect power cords during long periods of non-use.
Only use recommended rigging hardware as described in this guide.
These devices should be serviced by qualified service personnel when:
•
The power cords or plugs have become damaged.
•
Objects have fallen on and/or liquid has spilled into the devices.
•
The devices have been exposed to rain and/or moisture.
•
The devices do not operate normally or exhibit a marked change in performance.
Summary of Contents for PAR 38B FLOOD (E117)
Page 1: ...PAR 38B FLOOD E117 User Guide...
Page 12: ......
