Elife UNIDRIVE M series, Reference Manual

Page: 12 / 84

ALUMINIUM PLATE
THREADED METAL INSERT
D2
H2
D1
H1
VEHICLES BOARD
UNIDRIVE M Series
Figure 2.1:
A recommended installation method in order to ensure an effective heat
dissipation between the UNIDRIVE and the vehicle surface. The D2 ( H2 ) size listed in
figure must be greater than D1 ( H1 ) size. A thermal grease should be used on both sides of
aluminum plate to improve the heat exchange between UNIDRIVE and the vehicle board.
The additional aluminum plate is not included on UNIDRIVE.
Tips and Advice
A thermal grease should be used on the rear side of the UNIDRIVE heatsink to
improve the heat exchange between UNIDRIVE and the vehicle surface.
If the installation method shown in Figure 2.1 is not sufficient to ensure an effective
heat dissipation from the UNIDRIVE, you should install a Fan Cooler or a Liquid
Cooler on your UNIDRIVE.
8
Chapter 2
Installation and Wiring