45
1
2
3
4
English
11.4.4 Checking and tightening the drive belt for correct tension
• Remove the belt guard (Chapter 11.2.1).
• You can obtain the correct belt tension if you apply a point charge of 17lbs halfway through the
distance between the centres of the pulleys and you can measure a deflection of 1/2” on the
belt.
11.4.5 Tightening the belt for correct tension
To tighten the belt, proceed as follows:
1. Disconnect the belt drive by putting the right pedal in upright position.
2. Loosen the nut (M10) on the control rod with a 17mm spanner.
3. Pull out the beta pin.
4. Rotate the control rod 2 times to the right to tension the belt.
5. Place the control rod back in the engine plate and replace the beta pin.
6. Tighten the nut on the control rod (17mm spanner).
7. Check the belt tension.
CAUTION: in case of overtensioning, the clutch will not disengage.
If the belt is still too loose, please repeat these instructions.
Summary of Contents for Prof 5
Page 1: ...Prof 5 M A N U A L...
Page 10: ...10 English Caution For your safety use only genuine ELIET parts on ELIET machines...
Page 59: ...59 English...
Page 61: ......
