ELICA See you, Installation, Use And Maintenance Instructions

Page: 14 / 146

13
• Fit the hood into the hole made, by inserting it
from above , as shown in (Fig. 2).
Secure the hood inside the cabinet, by using the
specific fixing brackets provided (Fig.3). Fix the
brackets into the lower side of the hood in such
a way that there is a 2 meter distance between
the bracket lower side and the bottom of the
cabinet mm (Fig.4). This distance will allow to
pull the hood downwards during installation, in
order to make the stainless steel frame perfectly
adhere with the worktop.
Before inserting the screws into the cabinet,
make sure that the appliance is perfectly per-
pendicular with the worktop.
Place the suction unit under the appliance, by
making the downdraft air- outlet coincide with
the motor air-inlet.( FIG. 5 ); connect the two
flanges (indicated by the arrows in figure 5) by
means of the pipe supplied with the appliance,
and cut it accordingly to the cabinet height .
The downdraft rear air-outlet (fig. 6 ) can be
used only if the cabinet size allows you to do
so; in such a case the rear air-outlet flange
shall be installed after the downdraft has been
installed into the cabinet.
Some examples of installations are given in Fi-
gure 7 and 8
The motor air out-let shall be directed toward
the outside of the cabinet if the appliance is
used in the filtering version, or to the outside of
the house if the appliance is used in the aspira-
tion version.
• Place the metal box containing the electronic
components in an easily reachable area for
possible technical assistance operations, by
connecting the electric connectors of the box to
the hood (fig. 14).
• Connect the appliance to the power supply
After opening the glass, as specified in the ‘how
the hood works ‘ section of this manual, you
need to fit the grease filters and the charcoal
filters, in case the hood is used in filtering mode,
as well as the aesthetic grid.
Grease filters are mounted as shown in fig.11,
placing them inside the appliance until they re-
ach their seat; to remove them, please carry out
the reverse procedure.
Charcoal filters, if necessary, are fit before
mounting the grease filters, by following the
same procedure.
After mounting the filters, the aesthetic grid
shall be fit into the related housing, see figure
11 and 12. The grid is removed by grabbing it by
the specific knobs shown in figure 12.
How the hood works
In order to operate the appliance, it is necessary
to open the glass by following this procedure:
Push the glass downwards in the front side, as
shown in fig. 9; the glass will be released and
will open of about 2 cm,: then the glass shall be
rotated up to a 45° or 90° opening , based on
your needs. (see figure 10).
Following the glass opening, it will be possible
to operate the suction motor by using the push-
button panel as follows: