Installation and First Start-Up
- 23 -
7.4
Installation of the Magnetic Angle MW-007 for Version LMIX22-007
The magnetic angle must be centred to an arbitrary pole change. In order to determine a pole change, the
magnetic tape poles can be made visible by using the provided pole search film “POSU” (accessory
Figure 17: Installation of magnetic angle MW-007 for special version LMIX22-007
7.5
Offset
After the installation of the magnetic tape and the measuring system (sensor head), a value is transmit by the
interface. Because this value does not conform to the machine zero point, an offset should to be deposited at
the controller side.
NOTE!
An offset is necessary in each case of a replacement
of the encoder (sensor head) or magnetic tape.
7.6
Activation of the Device
The device starts automatically after operation voltage application.
Top view
16
30
12
20
Ø 5.5
20
12
.8
0.5
m
ax
.2
m
m
Front view
Top view magnetic tape
N S N
N
N
S
S
S N S
Summary of Contents for LMIX22-007
Page 32: ...Type Designation 32 Notes...
Page 33: ...Type Designation 33 Notes...
Page 34: ...Type Designation 34 Notes...
