Design and Functions
- 17 -
8
Design and Functions
8.1
DIL Switch Settings
In order to make settings or changes,
the cover of the evaluation box must
be removed.
To do this, loosen the four Phillips
screws on the upper side and then
remove the housing cover. The set-
tings can be made via sliders of the
6-pin DIL switch:
Figure 9: DIL switch
8.1.1
Setting the Output Levels
Table 3: Setting the Output Levels
DIL switch slider
OFF
ON
1
TTL – Line driver
24 V Push/Pull
8.1.2
Enable/Disable Speed Monitoring VMAX
Table 4: Enable/disable speed monitoring VMAX
DIL switch slider
OFF
ON
2
disabled
enabled
8.1.3
Set Operating Direction of VMAX
Table 5: Set operating direction for VMAX
DIL switch slider
OFF
ON
3
with positive
counting direction
with negative
counting direction
see also
8.3 Speed Monitoring (VMAX Output)
8.1.4
Set Resolution
Table 6: Set resolution (in mm)
DIL switch slider
0.1 mm
0.05 mm
0.025 mm
0.02 mm
0.01 mm
4
ON
OFF
ON
ON
OFF
5
ON
ON
OFF
OFF
OFF
6
ON
ON
ON
OFF
OFF
NOTE:
The desired configuration can be preset ex works if the appropriate
order information is given (see
DIL switch
positive negative
Summary of Contents for GMIX1A Series
Page 22: ... 22 Notes ...
