Elgento E26015, Instruction Manual

Page: 7 / 12

7 www.elgento.co
USING YOUR APPLIANCE
1. Make sure the unit is unplugged. Place unit
on a clean, dry surface.
2. Place ice shaving chamber in main body
and ensure it is seated on the shaft.
3. Twist the shaft in counter-clockwise to lock
into position.
4. Place the mixing paddle in bowl.
5. If mixing shaved ice with other ingredients,
place ingredients in bowl.
Note: Use the serving size markings as a guide
for appropriate ice and liquid levels. For a large
or small serving, fill the ice and liquid to the level
indicated on the bowl.
6. Slide bowl into groove on main body
and turn clockwise until it stops. This will
allow the mixing paddle to mix ice and
ingredients once operation begins.
7. Turn selector knob to desired setting. The
fine setting produces finer ice. The coarse
cone setting produces coarser ice.
8. Place ice in the ice shaving chamber. Do
not shave ice above MAX line.
9. Plug cord into outlet.
10. Place lid on main body and turn counter-
clockwise to engage the interlock switch
(power on/off) the unit will start and begin
to shave ice.
11. Turn lid clockwise to stop.
12. To remove bowl , turn counter-clockwise,
slide out and serve
WARNING: Cut Hazard - Avoid contact with the
Shaving Blade. Do not use if the Shaving Blade
is loose, cracked, bent or damaged.
CLEANING AND CARE
IMPORTANT!
• Remove plug from the mains socket, and
allow the appliance to cool down before
cleaning.
• Do not immerse the motor unit of the
appliance in water and make sure no water
enters the appliance.
• Clean the motor unit by wiping it with a
damp cloth. A little detergent can be added
if the appliance is heavily soiled.
• Do not use scouring pads, steel wool or
any form of strong solvents or abrasive
cleaning agents to clean the appliance, as
they may damage the outside surfaces of
the appliance.
• Be careful if you wash the cutter by hand,
as the blades are extremely sharp. If the
cutter is not properly attached, liquid may
seep out into the internal part of the base
unit. This may also be removed using
a slightly dampened cloth and a little
detergent.
IMPORTANT! Allow the unit to dry fully after
cleaning before using again. Do not use the
appliance if damp. Ensure the appliance is
completely clean and dry before storing.