IMPORTANT SAFEGUARDS
When using an electrical appliance, basic safety precautions should always be followed,
including the following:
Read all instructions and retain the instruction manual in a safe place.
Do not touch hot surfaces always use the handles and knobs
Do not immerse cord, plug or base unit in water or other liquids.
Close supervision is recommended when the appliance is used near children.
Switch off at the wall socket and then unplug this should be done when not in use or before
cleaning
Before cleaning. Always allow to cool fully before you start to clean.
Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions
or has been damaged.
The use of accessory or attachments is not recommended
Do not use outdoors or in wet/damp environments.
Do not let power cord hang over edge of table, counter, or touch hot surfaces.
Do not place on or near sources of heat.
Always fill the percolator first, then set the appliance onto the power base, and plug percolator
power base, into wall socket and switch on.
Do not operate when the water is below the minimum level.
Do not use appliance for other than intended for domestic use only.
Do not remove the cover is during the brewing cycle as steam is very hot and may scald.
Make sure the cover is secure before serving.
Warning! No user serviceable parts are inside; repairs should carried out by qualified
electrical personnel.
The use of accessory and /or attachments is not recommended by the appliance manufacturer.
This product is not intended to be used by children or the infirm without adequate supervision
or training
Supervision of children is reccomended to ensure that they do not play with is appliance
This appliance is not a Toy
1. Before using for the first time, thoroughly
was all parts of the percolator (see cleaning
and maintenance instructions section below.)
2.Remove cover, basket, lid and pump tube with
spring. Using the measurement markings
(located inside the body) fill the percolator
with the desired amount of water. For best
results be sure to use cold water when filling
the percolator. When preparing 4 cups, use
the tow spot weld marking just below 6
as the 4 cups level mark.
3.To help keep small coffee grinds from sifting through the holes in the basket, run cold
water over the coffee basket. Place basket on top of pump tube.Add desired amount
of coffee according to level markings on basket. Be certain to use a grind designed for
percolator coffee, or use a coarse grind. Finer grinds any sift through the holes in the
basket. The following chart serves as a guide for preparing various brew strengths.
Amounts can be varied to suit personal taste and particular coffees.
4.Place basket and pump tube assembly into
percolator so bottom of tube fits into well.
Place basket cover on top of basket and push cover
onto top of percolator. Caution: When placing the
lid onto the percolator. Be sure that the steam
outlets are always from the handle to avoid heat.
5.Place percolator on power base and pug base into
standard household 240V AC wall socket and
switch on.. The green power on indicator light
will illuminate.
Brewing begins within seconds and continues
at a rate of approximately once cup per minute.
6.Once brewing cycle is complete, the red indicator light will illuminate up signal your coffee
is ready. Warning: ensure the percolating process has stopped completely before removing
cover.
USING YOUR PERCOLATOR
