Step 5
Get the
Base Assembly
from the packaging.
Base Assembly Components
:
Qty. 1 - Base (#2568)
Qty. 4 - Rubber Foot (#2533)
Qty. 4 - Foot Rivet (#2583)
Base Assembly (F)
Step 6
Using the
Short Hex Key Wrench (H)
,
remove the two 1-1/4” socket screws and
washers from the
Arm & Axle Assembly
.
Step 7
Attach the Arm Assembly to the Base as
shown, using the same wrench and
hardware removed in the previous step.
Step 8
Feed the Inlet Hose, (male end first)
through the axle until about 2” to 3” is
sticking out of the threaded end of the axle.
Step 9
Slide the flange assembly onto the axle,
with the crank handle to the outside.
Step 10
Slide the Cam-Lever Brake onto the
axle. Be sure to align the tab on the
brake with the notch on the flange.
Step 11
Thread the Brass Swivel onto the
inlet hose. Hand tighten firmly.
Step 12
Thread the swivel onto the axle
as shown. Hand tighten firmly.
Page 3
Cam-Lever
Brake (G)
Inlet
Hose (A)
Brass
Swivel (E)
1-1/2” Screw
(Part #2521 )
1/4” Flat Washer
(Part #2331 )
Hose Clamp
(Part # 2539)
Serrated Flange Nut
(Part # 2330)
Step 13
Using the Long
Hex Key wrench,
remove the screw
hardware from the
Hose Clamp.
Arm Assembly
Components
:
•Arm (#2569)
•Short Axle (#2570)
•Axle Cap (#2561)
•Cap Screws (#2521)
•Arm Screws(#2519)
•Washers (#2520)
L
o
o
sen
L
o
o
s
en
Arm
Assembly (D)
