Page 7
Step A10
Use a 5/16 inch masonry
bit (not included) and drill
1-1/2 inch deep holes at
the 4 marked locations.
Helpful hints:
Measure and then mark
the masonry bit with
masking tape to ensure
you drill at the proper
depth. Clean the holes
with a shop vacuum.
Wear eye and dust
protection.
Step A11
Position the Wall Mounting Base over the drilled holes and tap the four 5/16” x 1-3/4” Sleeve
Anchor Bolts (2598) through the base and into the holes in the wall.
Step A12
Tighten the four sleeve anchor bolts with a 7/16 inch wrench.
Do not over tighten.
Perpendicular
Parallel
Perpendicular
Parallel
Proceed to step 13
on page 10.
