Connect the cable from the motor (which is mounted next to the right lifting column)
to the control box. Then connect the mains cable (4) into the AC / DC power brick
(located in the corner next to the motor) and connect it to the mains.
Tip:
The included stick-on cable clamps (D)
can be used to neaten the cable run.
Connect the motor and power cable
Please visit:
youtube.com/VisionAidTech
...for a video on how to setup and use your new Elevate 120 sit / stand desk
Setup Guide Rev 5
Applies to Matt and Glass top versions
Re-order Part #s:
K1672, K1673, K1674,
K1675, K1676, K1677
Install the feet (3) to the lifting columns (2) with the M6
screws (A x 8) and tighten them with the Allen key (C)
Please note:
The drawings below are for guidance only and may
differ slightly from the product and fittings received. Please contact
VisionAid’s support department should you have any queries.
Max. Weight Capacity
Warranty
50 kg (110 lbs)
3 years
690-1170 mm (27.2 to 46.1 inches)
230 mm (9.1 inches)
2 x USB-A, 1 x USB-C 18 Watt per port
AC In: 100/240V, 50/60Hz
DC Out: 29V 1.8A
0 to 40°C
Height Range
Drawer Stroke
Charging Ports
Power Supply
Working Environment
Warning:
Please take care to avoid damaging the tabletop when placing it upside down for assembly. Take extra special care when
handling the
glass version
and ensure nothing is dropped onto it. Damage during assembly is not covered by warranty.
Warning:
Please take
care to avoid damaging
the tabletop during
assembly. Take extra
special care when
handling the
glass top
version
and ensure
nothing is dropped
onto it as this may
cause it to smash and
this is not covered by
warranty.
Join the lifting columns (2) to the tabletop (1) using the 8 x M8 (B)
screws (4 on each side) and tighten with the Allen key (C).
Install the feet
Install the lifting columns (2) onto the tabletop (1)
Fixings list
Technical data
Component list
1. Tabletop x1
2. Lifting columns x 1
3. Feet x 2
4. Mains lead x 1
5. Wooden monitor arm
support bar
5
4
4
Motor
3
3
A
C
C
B
1
2
2
1
2
