ELETTROLASER MS 3.5, End-User And Maintenance Manual

Page: 68 / 108

code: UMS012 review: 0.2 date: 20/04/2022
Laser Welding machine - MS 3.5
user and maintenance manual page 68 of 102
•
Electrostatic charges that are still present after switching off the machine;
•
Hot parts of the machine.
8.2 Preparation for start-up
Before starting MS 3.5 you must make sure that the electrical system of the building where the machine is installed is activated.
Please refer to indications supplied by the respective manufacture-installation service to activate the electrical system.
Before starting the machine, make sure that the suction system (not supplied with the machine) is already active and functioning.
8.3 Tensioning
Follow the sequence of operations described in the following Tab. 8-1 to perform the tensioning of MS 3.5.
Symbol Action Feedback / notes
Check that the plug is plugged into the network socket (please
refer to paragraph 6.8).
Check that the red “ EMERGENCY ” button is not pressed. If this
is the case, reset the button.
Turn the power switch to “I”
The operator panel display will turn on and
the home page will display the message
“Machine locked. Turn the key.”
Tab. 8-1 – Tensioning