Technical Data
Power supply
Solar
Temperature range
–25 °C to +60 °C
Protection class
IP 43
Radio frequency
868,3 MHz
Standby
≥
12 hours
Setting the threshold values
A multiple contact switch for wind is provided on the underside
of the Ventero-868. The switch has several settings, which can
be modified with a small screwdriver.
Wind
Setting
1
→
Retract at low wind speed
Setting 2 bis 10
→
Intermediate levels
Setting
4
→
Factory setting
Setting 11
→
Retract at high wind speeds
11
1
3
5
Installation
Before installing the unit at the required position, check the proper
function of the Ventero-868 and the receiver.
Mounting options for Ventero-868
The wall bracket can be swivelled between –5° and 180°.
Secure the required position once it has been set (see screw a).
a
Wall bracket
rotated 90°
Wall bracket
rotated 180°
Mast and corner mounting
Optional accessory
(Article no. 24 269,0201)
Checking the wind function
1. Take the awning to the middle position with the manual
transmitter.
2. Set the multiple contact switch for the wind value (at the bottom
of the device) to setting 1.
3. Turn the wind vane several times.
The awning will retract.
4. Set the multiple contact switch for the wind value to the
required setting.
Advice:
In the event of a wind alarm, the keys are disabled for
15 minutes.
Deleting the Ventero-868
Press the
UP
and
DOWN
keys
simultaneously
for
at least 3
sec
.
Green LED (transmit) goes out briefly.
The Ventero-868 is deleted from the receiver.
red LED
Maintenance
The Ventero-868 is maintenance-free, but the cover must be
cleaned from time to time.
Otherwise, light entry is limited and shortens functioning time.
Fault
Cause
Remedy
• Awning retracts
automatically
• No travel com-
mand can be
issued via the
manual trans-
mitter
• Awning does not
retract in windy
conditions
• Receiver does
not accept
Ventero-868
• Wind alarm
• Ventero-868 is not char-
ged
• Poor radio connection
• Wind alarm is active
• Battery in the manual
transmitter is dead
• Motor has no power
supply or is overheated
• Wind threshold value is
set incorrectly
• Wind vane is faulty
• Ventero-868 is already
programmed
• Wait for wind interlock
to be deactivated (15
min.) or briefly interrupt
power supply.
• Charge Ventero-868
• Change position of
Ventero-868
• Wait (15 minutes)
• Change battery
• Check voltage
• Set correct value
• Delete Ventero-868
Important!
The Ventero-868 only operates in combination with radio
receivers from the elero ProLine-868 radio system.
Caution
Up- or downwinds blowing against façades may
cause destruction of equipment.
The Ventero-868 is
not
able to recognise these.
Please pay attention to this advice when choosing
your mounting position.