elero VarioTel-915, Operating Instructions Manual

Page: 7 / 8

USA-12
US
A
USA-11
Operating voltage 3 V DC
Battery requirements 2 x LR 03 (AAA)
System of protection IP 20
Permissible ambient temperature –10 to +55 °C
Operating frequency 915,3 MHz
Dimensions in mm L 121 x W 43 x H 23
Deleting individual transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Open the front cover on the device and press the following
buttons simultaneously :
• Programming button P
• STOP button
2. Keep these two buttons pressed until the LED goes out briefly.
Deleting all transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Open the front cover on the device and press the following
buttons simultaneously :
• Programming button P
• UP buttpm
• STOP button
• DOWN button
2. Keep all of these buttons pressed until the LED flashes 3 times.
Technical data
The maximum radio range is 25 m indoors and 350 m outdoors.
Deleting radio channel settings/Technical data
Intermediate position for roller
shutter/awning/venetian blind
Adjustment to Pos
B
Prerequisite: The transmitter has been programmed.
1. Press the UP button twice in quick succession .
2. The drive will adjust the curtain/canopy/blind into the stored
intermediate position. If no intermediate position is stored,
the curtain/canopy/blind is automatically adjusted into the
lower limit position.
Adjustment to Pos V (roller shutter, awning)
Prerequisite: The transmitter has been programmed.
1. Press the UP button twice in quick succession .
2. The curtain/canopy is adjusted into the stored ventilation
position. If no ventilation position is stored, the curtain/
canopy is automatically adjusted into the upper limit position.
Adjustment to Pos V (venetian blind)
Prerequisite: The transmitter has been programmed.
1. Press the UP button twice in quick succession .
2. The blind is adjusted into the stored reverse position. If no
reverse position is stored, the blind is automatically adjusted
into the lower limit position.
Deleting Pos B
1. Press the following buttons simultaneously :
• DOWN button
• STOP button
2. Keep these two buttons pressed until the LED goes out briefly.
Deleting Pos V
1. Press the following buttons simultaneously :
• UP button
• STOP button
2. Keep these two buttons pressed until the LED goes out briefly.