elero VarioTec-868 DC, Operating Instructions Manual, Page: 6 / 15

10 | EN Ⓒ elero GmbH
Ⓒ elero GmbH EN | 11
3.1 Scope of delivery
‰
Control panel
‰
ProLine adapter frame
‰
Power supply
‰
Operating instructions
3.2 Description of the device and operation
Description of the device
from left to right
Control panel
First adapter frame:
not included, optional
for installation in stan-
dard switch programs
Second adapter frame:
ProLine adapter frame
for single installation
power supply
9DULR7HF-$50
3RV 3RV
5HVHW
'2:1EXWWRQ
6723EXWWRQ
83EXWWRQ
$ODUPVLJQDO
&RYHU
0DQXDO$XWRPDWLF
326EXWWRQ
326EXWWRQ
5HVHWEXWWRQ
3
3EXWWRQ
Operating unit
General view
closed
9DULR7HF-$50
3RV 3RV
5HVHW
'2:1EXWWRQ
6723EXWWRQ
83EXWWRQ
$ODUPVLJQDO
&RYHU
0DQXDO$XWRPDWLF
326EXWWRQ
326EXWWRQ
5HVHWEXWWRQ
3
3EXWWRQ
Operating unit
Detail view
under the cover flap
2Q
Operating unit rear
Coding switches 1 to 3
Fig. 1 Device Views
Functional Elements
‰
Emergency signal indicator light (LED):
See Fig. 5, "LED Status and Explanation“
‰
Sliding switch
Auto/Manual
:
In "Auto" position, automatic drive commands are execut-
ed (control signals via group control inputs).
In "Manual" position, only manual drive commands and
emergency signals are executed.Switching of the ope-
rating mode "Auto/Manual" by a hand-held transmitter is
ignored. Switching is possible only with the slide switch
on the device.
However, the current Auto/Manual state is always shown
on any programmed bidirectional hand-held transmitter.
‰
Button [
UP ▲
]
:
upward or inward movement
‰
Button [
DOWN/CLOSE ▼
]
:
downward or outward movement
‰
Button [
STOP ■
]
:
stop movement
‰
Button [
P
] (under the cover flap):
Simulation of a power supply interruption;
is required for programming a transmitter.
‰
Button [
Pos ▼
] (under the cover flap):
Programming an Intermediate Position,
Deleting an Intermediate Position.
‰
Button [
Pos ▲
] (under the cover flap):
Programming a Ventilation/Turning Position,
Deleting a Ventilation/Turning Position.