elero DFE 100, Assembly Instructions Manual, Page: 3 / 16

1. Safety instructions
1.3 Safety function
Doors which are fitted with an elero rolling door drive and
operated with an elero control system, have to have the legally
prescribed accessories for safe operation (e.g. opto-electric
door-edge security systems, wind-up protection systems, light
barriers, etc.).
This higher-level safety system guarantees additional personal
and property protection.
1.4 Transport
If the drive arrives in a damaged condition despite proper
packaging, then it must not be commissioned. Immediately
complain about the damage to the transport company.
Repair notes can be found on page 14.
In case of unauthorised removal of the necessary covers,
improper use, incorrect installation or operation, there is a danger
of severe injury to persons and substantial damage to property.
1.5 Target group
All installation, initial operation and troubleshooting work must be
carried out by an electrician.
(Please observe IEC 60364 and/or CENELEC HD 384 or
DIN VDE 0100 and IEC 60664 or DIN VDE 0110 and national
accident prevention regulations).
An electrician in the sense of these general safety instructions
is a person acquainted with the assembly, installation and initial
operation of the product with appropriate qualifications.
All work in the other areas, for example operation and disposal,
must be carried out by suitably instructed persons.
1.6 Intended use
Rolling door drives are only designed for use with rolling doors,
roller grilles or sectional doors without counterweight.
Commissioning (i.e. beginning of intended operation) is only
allowed if the valid EMC guidelines (2004/108/EU) are observed.
The technical data and the information on connection conditions
can be found on the type plate and in this documentation and
must be strictly adhered to.
WARNING!
Observe the following safety instructions
Failure to observe them can lead to bodily injuries!
General
• The assembler must check that the ambient temperature range stated on the drive is suitable for the installation site.
• Never install or commission devices which are damaged.
• Never hammer the drive as this will damage the bearings and housings.
• Only use unmodified original
elero
®
parts.
• If the device is opened without permission or used in an improper manner, or if it is incorrectly installed or operated,
there is a risk of damage to persons and property.
• The device contains small parts which can be swallowed.
Installation
• All installation work must be carried out by an electrician.
• The place of installation must be cordoned off due to the danger of falling objects.
• This electrician must be suitably qualified.
• Observe any country-specific conditions when installing the device.
• The device may only be used by persons who have read and understood the operating instructions.
Operation
• Only use indoors (please observe the stated degree of protection).
• If the rolling door drive is used outdoors, then the connecting cable has to be laid properly in a shield tube and the sta-
ted degree of protection followed.
• If one or more transmitters are used for controlling the system, its operating range must stay visible during operation.
• Keep people away from the system until it is at standstill.
• Keep children away from the (remote) control units.
• Ensure that there are no children within the door’s operating range.
• Observe the control documentation.
1.7 Important safety instructions
© elero GmbH EN | 3