
Mounting and technical data
Technical data
Protection class:
IP44 (after correct installation)
Supply voltage:
110 V to bis 230 V, 50 to 60 Hz
Power consumption:
0,5 to 5 W
Output:
1 potential-free changeover contact
5 A / 250 V
Ambient temperature:
– 20 °C to + 50 °C
Dimensions:
300 x 170 x 65 mm
Weight: 0,42
kg
Maintenance
The Aquero must be freely accessible and must not be overgrown
by vegetation.
The Aquero is maintenance-free; however, the sensor surface
must be cleaned from time to time using a moist cloth without clea-
ning agents.
Permissible mounting position
4. Switch off the mains voltage.
5. Connect the Aquero, observing the correct wiring colours.
PE
50 ... 60 Hz
N
L
Mains 1
10
... 230 V A
C Rain alarm
Mains
110 ... 230 V
50 ... 60 Hz
C
NC
NO
N
L
PE
Rain signal
Mains unit
Aquero
Multipoint connector/supply voltage
Sensor PCB
6. Push the mains unit PCB carefully back into the wall plinth.
Make sure that the PCB is located in the guide rail.
7. Push the mains unit PCB cover back onto the wall plinth and
screw it tight.
8. Switch on the mains voltage again.
After 2 minutes, the Aquero is ready for operation.
The terminal configuration in the device is as follows:
L Mains
N Mains
PE Protective earth
C Rain
alarm
NO Rain alarm
Connection example
aerotecaquero
PE
N
L
C
N L
Mains
2
3
1
5
3 4
6
1 2
Sensor
Central
N
L
PE
Mains
NO
C
NC
N
L
PE
Aquero
Aero
AeroTec
1
Z
M
Important safety instructions!
Observe the following instructions.
Danger of injury due to burns!
• The sensor surface may reach a temperature of up
to 60 °C.
• Only touch the sensor surface with great care.
• Check the function of the Aquero by splashing water
onto the sensor surface..
Caution!
Fault
Cause
Remedy
The awning does Aquero is dirty
Clean Aquero
not retract when
it rains
Aquero is mounted
Mount Aquero
incorrectly
correctly
→
see ‘Permissible
mounting position’
Troubleshooting
Horizontal wall
mounting position
We reserve the right to make technical changes
elero GmbH
Antriebstechnik
Linsenhofer Straße 65
D-72660 Beuren
Fon: +49 7025 13-01
Fax: +49 7025 13-212
www.elero.com