-7-
ASSEMBLE COMPONENTS TO THE PC BOARD
Figure B
Diodes have polarity.
Mount them
with the band in the correct direction,
as shown on the top legend.
Figure C
Electrolytics have a polarity
marking indicating the (–) lead.
The PC board is marked to
show the lead position.
Wire 1” - Cut a 1” wire and strip
both ends. Solder one end to
the PC board marked (–).
Wire 1” - Cut a 1” wire and strip
both ends. Solder one end to
the PC board marked (+).
C4 - .47
µ
F (474) mylar cap.
T1 - Transformer
Q1 - Transistor 2N6121 (Fig. A)
R1 - 200
Ω
5% 1/4W resistor
(red-black-brown-gold)
C3 - .1
µ
F (2A104K) mylar cap.
R4 - 1M
Ω
5% 1/4W resistor
(brown-black-green-gold)
C1 - 470
µ
F lytic capacitor
(see Figure C)
Band
Epoxy
PC board
marking
Figure D
Mount the SCR in the same direction as marked on the PC
board.
Polarity
marking
(–)
(+)
T2 - Trigger transformer
D1 - 1N4004 diode
(see Figure B)
C5 - .033
µ
F (333) mylar cap.
SCR - T106D1/C106D1 SCR
(see Figure D)
R2 - 1M
Ω
5% 1/4W resistor
(brown-black-green-gold)
R3 - 2M
Ω
5% 1/4W resistor
(red-black-green-gold)
NE - Neon lamp
C2 - .1
µ
F (2G104K) mylar cap.
VR1 - 2M
Ω
potentiometer
(see Figure E)
Metal
backing
With beveled edge
Figure A
Bend the leads of the transistor in the
direction shown below.
Mount the transistor onto the PC
board in the direction shown below.
3/16”
Bend
leads 90
O
Figure E
Cut off the tab on the potentiometer as shown. Install the potentiometer so that the
black section is even with the PC board as shown.
Cut off tab
Potentiometer
PC Board
Black
section of
potentio-
meter
