Correct fi tment is very important to ensure the long life of your cover and your van. Our covers have been designed with ease of fi tment in
mind. By following these general instructions, your cover should go on quickly and easily.
STEP 1
Remove cover from box & layout
on a dry, fl at surface on the opposite
side of the van to the main entry. Locate
the tag marked FRONT found on the
hem section of the cover. Once the front
section is located, stretch the cover out
until you fi nd the zippered side panels.
STEP 2
Undo the zippers & with (1)
person positioned at the front & (1)
person at the rear, stretch the cover out
so that you can fl ip the unzipped side
panels onto the waterproof roof section
of the cover so that side is completely
open.
STEP 3
Lift the cover over the top of
the van and slowly pull it over the roof
area. We suggest using a step ladder or
platform to help with this process.
STEP 4
The securing straps of the cover
can also be used to pull the cover over
the roof of the van. Remember to take
special care of air conditioning units,
solar panels, antennas, and other pro-
truding objects.
STEP 5
When pulling the cover over the
roof be careful not to cause any damage.
If the cover does not slide freely, check
that it is not caught on something. Do
not attempt to fi t the cover during high
winds or bad weather.
WARNING
Do not over tighten straps as pulling the cover too tight may place undue tension on the seams and sharp edges.
Prestige Covers are designed for storage purposes only and should not be fi tted while towing or transporting your van.
STEP 6
Once the cover has been pulled
over check it is sitting evenly. Position
the skirting around the base & corners
of the van to ensure it is not caught on
stabilisers or other sharp objects. Zip up
the side panels.
STEP 7
With the cover is in place begin
securing the cover using the buckle
straps located along the base of the
cover. Throw the long straps underneath
the van so they reach the opposite side.
Fasten the buckles and pull the straps
fi rmly to hold the cover in place.
STEP 8
The cover features reinforced
vinyl tabs located on all four corners of
the cover. These tabs are designed to
take up any excess material.
STEP 9
Using the rope supplied, tie one
end to a reinforced vinyl tab. Create
a criss-cross eff ect with the rope and
secure but do not overtighten.
Do not
use octopus straps or bungee cords as
they can pull the grommet out of the
tab. Do not use these tabs to secure the
cover to the ground in any way.
FITTING THE COVER