INSTALLATION MANUAL
8
5 Connection
This appliance must only be connected to a 230/240 Volts AC
50Hz supply. Before connecting the fire, check that the supply
voltage is the same as stated on the fire.
It is important that the outlet is located outside the installation
location so that the socket is easily accessible and the plug
can be disconnected from the stove after installation.
After the fire is attached to the wall and connected to the
socket, the surround (the chimney) can be placed around it.
This appliance must only be used on a AC supply, fuse rating
13Amp. The wires in the mains lead are coloured in accordance
with a standard UK supply, these being:
•
GREEN/YELLOW – EARTH
•
BLUE – NEUTRAL
•
BROWN – LIVE
As the colours of the mains lead of this appliance may not
match the coloured markings used to identify the terminals in a
plug, please observe the following
•
The green and yellow wire must be connected to the
terminal in the plug which is marked with the letter E or
Earth symbol.
•
The blue wire must be connected to the terminal in the
plug which is marked with the letter N.
•
The brown wire must be connected to the terminal in the
plug marked with the letter L.
•
Replace fuses only with fuses of the correct size and rating.
Maintenance
Maintenance to this device may only be done by a qualified
professional. It is adviced to maintain your fire at least once
every 12 months.
WARMING:
Before reparation or maintenance check whether the fire is
unplugged.
CAUTION
In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through
an external switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by the utility.
Your main power supply is attached to the IEC through the back
of the fire, see
Figure 1
.
The on/off switch, also used to activate connection to your app,
is located on the underside of the fire, approximately 100mm
from the rear of the stove, off-set to the right hand side, see
Figure 2.
Figure 1 - Position of main power supply at the back of the fire
Figure 2 - Position of the On/Off switch on the front of the fire
