elem CBE25022-1B21, Original Instructions Manual, Page: 21 / 30

21
u Take care to keep the mains cable away from the
cutting line. Always be aware of the position of
the cable.
u Keep hands and feet away from the cutting line at
all times, especially when switching on the motor.
u Before using the appliance and after any impact,
check for signs of wear or damage and repair as
necessary.
u Never operate the appliance with damaged
guards or without guards in place.
u Take care against injury from any device fitted for
trimming the filament line length. After extending
new cutter line always return the machine to its
normal operating position before switching on.
u Always ensure that the ventilation slots are kept
clear of debris.
u Do not use the lawn trimmer (edge trimmer), if
the cords are damaged or worn.
u Keep extension cords away from cutting
elements.
Warning! Switch off, remove
plug from mains before
adjusting, cleaning or if
cable is cut, damaged or
entangled.
The cutting line continues
to rotate for a few seconds
after the trimmer is
switched off.
Caution – do not touch
rotating cutting line.
WARNING: Packaging
materials are not toys!
Children must not play with
plastic bags! Danger of
suffocation!
ELECTRICAL SAFETY
Always check that the
power
supply corresponds to the
voltage on the rating plate.
Electrical Safety
Your machine is double insulated for safety and
requires no earth connection. The operating voltage
is 230 V AC, 50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use approved extension
cables.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
DESCRIPTION
1.
Mains cable
2.
Cable holder
3.
Starting switch
4.
Handgrip
5.
Motor housing
6.
Guard
7.
Spool holder
8.
Cutting knife with cover
ASSEMBLING
Do not connect the machine
to the mains socket before
it is completely assembled.
The grass trimmer is supplied with some
components not assembled. To assemble these
proceed as follows:
Assembling the motor housing
Insert the motor housing (5) into the handgrip (4),
make sure the cable between will not be damaged.
Mounting the guard
Align the reference indices of the body (2) of the
spool holder (3) and of the guard (4). Insert the
guard in the body (up to the collar) and rotate it in
the direction indicated by the arrow until the hole of
the guard corresponds to that of the body. Firm the
screws supplied (1).
Caution! During this operation beware of the line
cutter blade. You may be wounded.
Caution! Never use the grass trimmer without the
guard. It is vital for your and other peoples’ safety
and for the good working order of the trimmer. The
failure to observe this safety regulation is not only
dangerous but also annuls the guarantee terms.
Use of the cable holder
The handle is equipped with a cable holder that
serves for connection of the extension cable.